http://backend.userland.com/rss092 http://tampabay.dsm.org/phpBB/ tampadsm@gmail.com tampadsm@gmail.com Sat, 21 Nov 2009 00:07:29 GMT http://tampabay.dsm.org/phpBB/viewtopic.php?p=103625#103625 Mike
Subject: running issue.
Posted: Fri Nov 20, 2009 1:58 pm (GMT -5)
Topic Replies: 0

Im workin on this project and have an issue with it. Its very hard to start, and really does not want to stay running. After getting some heat into it, its a little happier, but still not right.

When i give it some gas (neutral) it has a hesitation then will rev, almost like its fighting to get up there. Ive been able to set timing to 5 degrees. it had a bad TPS, replaced that and set to .500v and it works full range. I know my fuel system is working well. Only thing I can figure is that I might have low compression due to a low vacuum reading. also new plugs, and a perfect working COP setup (tested COP, ECU, MAS, CAS, on other cars to verify working perfectly)

Im waiting to get my compression tester back so I can see my numbers. Bottom end is a stock rebuild with used pistons, rings, new bearings. Head was just taken from another motor that supposedly ran good.

Any ideas other then what ive stated would be awesome cause im lost at this point.
_________________
Mike
'95 Lancer GSR
'90 Talon
'89 ???
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103624#103624 Mike
Subject: Innovative XD-16 Gauge and LC-1
Posted: Wed Nov 11, 2009 11:43 pm (GMT -5)
Topic Replies: 0

Both, all there.

http://www.innovatemotorsports.com/products/MTS.php

$150


Edit: Sold
_________________
Mike
'95 Lancer GSR
'90 Talon
'89 ???
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103623#103623 LS1Fever
Subject: Garage clearout! Need to sell!
Posted: Mon Nov 09, 2009 12:22 pm (GMT -5)
Topic Replies: 0

I need this stuff gone. I will try to borrow a camera today and get pics. If you are interested in something, the best way is to call me. 813-381-9738. Name is John.

98 Talon front bumper - $110
98 Talon rear bumper - $110
98 Talon high spoiler - $110
Entire conversion - $300

95 Talon rear bumper - $80
2g tan door panels - $50
2g tan glove box - $20
2g sunvisors - $30
2g turbo speedometer w/67,415 miles - $50
2g black dash - $85
2g black pass airbag - $85
2g black e-brake - $15
2g black steering cover *top* - $10
2g black radio bezel - $10
2g black gauge pod - $5
2g black dual gauge pod - $30
2g black HVAC control - $30
2g black cruise control switch - $25 *have 3*
2g black hazord panel - $25
2g black interior door handles w/covers - $30
2g black power window/lock switches - $20
2g black center vents - $25 *have 2*
2g black/gray doorpanels - $30
95 Talon taillights - $40
2g silver rearview mirrors *passanger side needs glass* - $30
95 talon fogs *one has slight crack on lens* - $20
2g battery tray - $15
1g center console - $15
*2* 16x7 probe 5x114.3 rims - $40 (good for drag radials)
2g throttle body elbow - $10
_________________
95 TSI AWD *Paint job in the works & stroker motor by Lancerman!*
Everything else, you will have to wait and find out!
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103622#103622 CT9A-MR
Posted: Sat Nov 07, 2009 9:10 pm (GMT -5)
Topic Replies: 7

Nice work Harry, I am sure its more fun to drive than the bimmer.
I have always loved these cars.
_________________
Glen
06 Evo MR
3" Cat back, Intake, boost controller, 255 walbro/745cc, Street FMIC, gt3071, FP4 and 93 pump.
12.2 on TTP Mustang Dyno & http://www.ttp-engineering.com/ FLASH!
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103621#103621 awd-tsi
Subject: Pictures
Posted: Sat Nov 07, 2009 12:45 pm (GMT -5)
Topic Replies: 7

Updated with pics

http://ztuner.com/wz.htm
_________________
08 BMW 335i DD
07 Mazdaspeed 3 - SOLD
90 300zxtt - Stage III - SOLD
91 300zxtt - Stage XXX Running finally
90 300zx 2 + 2 TT - SOLD
92 AWD DSM - SOLD !!!
2000 Infinity I30 - DD
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103620#103620 CT9A-MR
Posted: Wed Nov 04, 2009 1:25 pm (GMT -5)
Topic Replies: 2

MR BBS: 17x8 +38
I have read on evo m that these are actually 17 lbs but I don't have a digital scale to verify.

Evo's have had 255's on this wheel.
_________________
Glen
06 Evo MR
3" Cat back, Intake, boost controller, 255 walbro/745cc, Street FMIC, gt3071, FP4 and 93 pump.
12.2 on TTP Mustang Dyno & http://www.ttp-engineering.com/ FLASH!
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103619#103619 steve96gst
Subject: Evo aluminum halfmoon gasket
Posted: Wed Nov 04, 2009 12:08 pm (GMT -5)
Topic Replies: 0

Works in the 4g63 and wont break part # MD-372348
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103618#103618 awd-tsi
Subject: >>
Posted: Wed Nov 04, 2009 10:04 am (GMT -5)
Topic Replies: 2

Whats the width on these wheels ?
_________________
08 BMW 335i DD
07 Mazdaspeed 3 - SOLD
90 300zxtt - Stage III - SOLD
91 300zxtt - Stage XXX Running finally
90 300zx 2 + 2 TT - SOLD
92 AWD DSM - SOLD !!!
2000 Infinity I30 - DD
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103617#103617 CT9A-MR
Subject: Grey BBM MR Evo Wheels
Posted: Tue Nov 03, 2009 6:54 pm (GMT -5)
Topic Replies: 2

SOLD!!!
1 has a little rash but its hard to see with tires that have curb protection.
I am totally honest about the wheels. They are in great shape other wise.
Very light at 18 lbs.














_________________
Glen
06 Evo MR
3" Cat back, Intake, boost controller, 255 walbro/745cc, Street FMIC, gt3071, FP4 and 93 pump.
12.2 on TTP Mustang Dyno & http://www.ttp-engineering.com/ FLASH!
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103616#103616 Mike
Subject: Carfax
Posted: Tue Nov 03, 2009 1:22 pm (GMT -5)
Topic Replies: 0

anyone have access to Carfax? I want to get a report on my roommate's new Infiniti I30t.
_________________
Mike
'95 Lancer GSR
'90 Talon
'89 ???
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103615#103615 Vapor
Subject: Back to stock Evo sale. OEM parts wanted too
Posted: Sun Nov 01, 2009 4:22 pm (GMT -5)
Topic Replies: 0

Tanabe Pro Se7en coilovers, camber plates included, also has electronically adjustable dampening from cock pit - 950

15mm bolt on spacers (pair) -50

GSC 272s - 200

AMS FMIC - 200

Evo 9 tails - 100

JDM Evo rear bumper, painted blue by you and black (on the diffuser portion), looking for trade with oem blue by you rear bumper +500 cash

Evo 9 seats, front and rear, trade for Evo 8 seats + 500

Megan racing test pipe with o2 bung (no cel) - 50

Orbital double din panel and a/c controls 125

Evo 9 turbo, 30k miles, no shaft play, includes ported exhaust manifold, and stainless o2 elbow - 600

Forge wastegate actuator for evo 9 - 100

Hallman pro Evo boost controller - allows in car adjustment - 50

Nisei engineering lower intercooler pipe - 40

Evo 9 blow off valve - 50

----------Need following stock items---------

set of 20 oem lug nuts

OEM suspension

trunk carpeting

stock intercooler
--------------------------------------------

for fastest response please email me at johnpsi at gmail dot com. All items are currently installed and will be removed this week.
_________________
John

03 BBY Evo - BPU'd
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103614#103614 CT9A-MR
Posted: Sun Nov 01, 2009 1:10 pm (GMT -5)
Topic Replies: 28

Thanks guys. I will take some better pic's showing the side angle and the tires.

I do have a buyer for the stock BBS MR. Mike if your interested Pm me a price since I would prefer not to have to ship.
_________________
Glen
06 Evo MR
3" Cat back, Intake, boost controller, 255 walbro/745cc, Street FMIC, gt3071, FP4 and 93 pump.
12.2 on TTP Mustang Dyno & http://www.ttp-engineering.com/ FLASH!
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103613#103613 Turbo Lag
Posted: Sat Oct 31, 2009 12:30 pm (GMT -5)
Topic Replies: 28

Nice look wheels Glen

Are you keeping the stockers? or selling them?
_________________
MIKE
05 WW Evo VIII A few bolt on's
WWW.EVOwned.COM

]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103612#103612 awd-tsi
Posted: Thu Oct 29, 2009 11:08 pm (GMT -5)
Topic Replies: 28

NICE !!! i like the lack of weight
_________________
08 BMW 335i DD
07 Mazdaspeed 3 - SOLD
90 300zxtt - Stage III - SOLD
91 300zxtt - Stage XXX Running finally
90 300zx 2 + 2 TT - SOLD
92 AWD DSM - SOLD !!!
2000 Infinity I30 - DD
]]> http://tampabay.dsm.org/phpBB/viewtopic.php?p=103611#103611 CT9A-MR
Posted: Thu Oct 29, 2009 7:59 pm (GMT -5)
Topic Replies: 28

New wheels for the MR.



The pictures do not do them justice.

Just under 14lbs and you can definitely "feel" the difference.
The tires are 245/45/17 dunlops on 17 x 9 Buddy Club QF.
I will take some rear shots, I love the meaty look.
_________________
Glen
06 Evo MR
3" Cat back, Intake, boost controller, 255 walbro/745cc, Street FMIC, gt3071, FP4 and 93 pump.
12.2 on TTP Mustang Dyno & http://www.ttp-engineering.com/ FLASH!
]]>